Forum Domoticz en français

Code : Tout sélectionner

http://192.168.1.44:8084/json.htm?type=command&param=switchlight&idx=214&switchcmd=DisableSetPoints=True

Code : Tout sélectionner

../json.htm?type=command&param=updatetimer&idx=timerID&active=true&timertype=3&hour=0&min=20&randomness=true&command=0&days=12345

Code : Tout sélectionner

-- Definitions
commandArray = {}
local DOMOTICZ_IP = '127.0.0.1:8080'
local DEVICE = "THE NAME OF YOUR VIRTUAL THERMOSTAT SWITCH" --In my sample, "Thermostat Switch"
local DEVICE_ID = YOUR_SETPOINT_DEVICE_ID

-- Main script
if devicechanged[DEVICE] then 
    
    json = assert(loadfile '/home/pi/domoticz/scripts/lua/JSON.lua')()  -- For Linux
    --   json = (loadfile "D:\\Domoticz\\scripts\\lua\\json.lua")()  -- For Windows
    
    --load all setpointtimers for the DEVICE_ID
    local url = 'http://'..DOMOTICZ_IP..'/json.htm?type=setpointtimers&idx='..DEVICE_ID
    --print (url)
    local config=assert(io.popen('curl "' .. url .. '"'))
    
    local blocjson = config:read('*all')
    config:close()
    --print ('blocjson:' .. blocjson)
    local jsonResult = json:decode(blocjson).result

    local vrb= "disablesetpointtimer";
    local NewLevel = devicechanged[DEVICE];
    print ('New level command:' .. NewLevel)
    if NewLevel == "Automatic" then
        vrb = "enablesetpointtimer";
    else
   	local temp = 6
        if NewLevel == "Comfort" then
            temp = 21
        elseif NewLevel == "Economic" then
            temp = 18
        end
        
        --update the Setpoint to the predefined temperature
        commandArray['UpdateDevice'] = DEVICE_ID .. "|0|" .. temp
    end
    
    --change all setpointtimers of DEVIDE_ID to the desired state : disabled of enabled
    for i,setpoint in ipairs(jsonResult) do
        os.execute ('curl "http://' .. (DOMOTICZ_IP) .. '/json.htm?type=command&param='..vrb..'&idx=' .. (setpoint.idx) ..'"');
    end
end 

return commandArray